ShapeArray (SAA)
Step-by-step guides for various tasks using Measurand ShapeArrays (SAAs).
Flush mounted boreholes or installations are finished so that the instrumentation is entirely below ground; nothing is left sticking above the ground. This...
Thu, 14 Jan, 2021 at 2:07 PM
The SAA X-mark Protractor is used to measure an azimuth offset angle between a known direction and the physical X-Mark on a ShapeArray (SAA). Applying this...
Thu, 6 Jul, 2023 at 9:47 AM
Introduction Thank you for your interest in the Measurand ShapeArray (SAA). Measurand's ShapeArray is a flexible, calibrated 3D measur...
Mon, 22 Jul, 2019 at 10:21 AM
ShapeArrays™ greater than 100 m in length are shipped in a reel crate. The bottom of reel crate is shaped like a pallet for easy lifting with a forklift. On...
Thu, 18 Aug, 2022 at 4:07 PM
The SAAScan has no way of knowing its position in the real world. Measurand’s SAAScan does not have magnetometers and cannot determine direction without an ...
Wed, 27 Mar, 2019 at 10:16 AM
Amphenol connectors are typically used to connect a ShapeArray (SAA) in environments where there is a reasonable chance of water exposure with the connecto...
Fri, 2 Nov, 2018 at 11:39 AM
Finding Azimuth Offset of an SAAV from the X-mark SAAV azimuth offset can be measured and input in to the ShapeArray software during data processing. Th...
Thu, 6 Jul, 2023 at 10:21 AM
The maximum cable lengths that can be used with ShapeArrays are directly related to the type of ShapeArray, the length of the ShapeArray, and the type of ca...
Thu, 13 Jul, 2017 at 11:15 AM
RST Snap Seal Casing that was previously damaged or cut can be repaired or extended using RST repair couplings. This process is typically done using an RST ...
Thu, 11 Feb, 2021 at 2:57 PM