SAACR_raw2data

Step-by-step guides for performing common tasks with Measurand's SAACR_raw2data software.

SAACR_Raw2Data How-To Guide
SAACR_raw2data application takes raw data files, usually created by a Campbell Scientific data logger, and converts them into Cartesian data files that can...
Wed, 6 Oct, 2021 at 2:09 PM
Using the SAACR_raw2data Magtool
This guide compliments the SAACR_raw2data How-To Guide and the SAACR_raw2data manual. This guide cannot be used on its own unless you are proficient with u...
Mon, 3 May, 2021 at 2:01 PM
Applying Adjustments to Data using SAACR_raw2data
SAACR_raw2data can apply software adjustments to raw data collected from ShapeArrays (SAAs) as it converts it to Cartesian data. In SAASuite 3.0 or high...
Mon, 3 May, 2021 at 2:01 PM
Creating Site Files for Convergence and Superset ShapeArrays
Measurand ShapeArrays are typically installed vertically or horizontally to monitor deformation. They can, however, be installed in special configurations t...
Mon, 3 May, 2021 at 2:01 PM
Converting SAAV Extend Data After an Extension
After data has been recorded from an SAAV Extend with a new data logger program, it should be collected from the data logger into the same project folder...
Tue, 15 Jun, 2021 at 4:13 PM
Creating an Archive To Improve Conversion Speed For Large Data Sets
Conversion of new data with SAACR_raw2data can slow down considerably over time as historic data accumulates. The processing time for new data can be signif...
Mon, 3 May, 2021 at 2:01 PM